Plug and Play System - 6000 Gallon - Advantage Bead and Glass Filters

Plug and Play System - 6000 Gallon

Plug N Play 6000 Flyer

Easiest filter system to install.
With the new Plug and Play System you can install the whole filter system in less than one hour. The system comes pre-plumbed with unions from the factory to insure proper installation each time. Simply lay down the pad, set the equipment in the areas marked on the pad and screw the plumbing unions together. No cutting or gluing of pipes.* All the electrical is controlled through the Advantage Electrical Control Tower. Just plug the equipment into the marked outlets on the Tower and then plug the Tower extension cord into the main power source (recommended 20 amp dedicated circuit).

Easiest filter system to maintain.
The Advantage Bead filter is extremely easy to maintain, requiring less than 5 minutes a week to back wash. Additionally, with the Plug and Play System, if a piece of equipment ever needs repair or replacement, you can easily remove each component without any tools. Simply unscrew the plumbing unions and unplug the unit.

Advatnage Plug and Play System Includes:

Advantage Bead 10 Filter
The best koi pond filter available for both excellent water quality and ease of maintenance. This filter is rated for ponds up to 10,000 gallons so you will never out grow this filter.

Emperor Aquatics 80 Watt HO Ultraviolet Sterilizer Light
This light is rated for ponds up to 10,800 gallons. Constructed with a 5 inch body with 2 inch inlet and outlet unions. A good UV Light will guarantee you never have green water in your pond.

Artesian 1/3 hp High Efficiency Pump
This pump is extremely efficient, operating at only 3.7 amps at 115 volts. Because it is a low speed pump it is also extremely quiet. Pump comes with a 3 year warrantee. We found this pump to be a perfect match for the 4,000 gallon system.

Standard Electrical Towers
This unit allows you to completely wire your new filter system in less than 5 minutes without the need for an electrician. All the equipment plugs into the lower electrical box and is controlled by the switches it the upper box. There is no need to plug or unplug any equipment under normal operation. The Electrical Control Tower needs to be plugged into a 20 amp electrical source. There is a number of options available for the Tower if you would like to customize a Tower to fill your particular pond needs.